#1950s swing clock mini grandfather how to#

To wind, simply insert the crank into the winding points turning clockwise approximately thirteen revolutions.

The lower the weight hangs, the closer it is to the end of the cycle. If the clock is put in silent mode, only the right weight will drop. The left weight is for the hour strike and makes a gong noise, at the top of each hour. The right weight keeps time and drives both the hands and pendulum. WINDING AN ANTIQUE GRANDFATHER CLOCKĪntique Grandfather clocks often have two weights and two corresponding winding points in the dial. If the clock is running too fast, or too slow adjust the nut on the bottom of the pendulum rod. The most effective way to wind your clock would be to open the front door, insert the crank, hold the clock steady with your left hand, and turn the crank with your right hand.Īfter winding the clock, set the correct time by moving the minute hand either clockwise or counterclockwise. You should be able to turn the key with minimal force if you are having difficulty please consult with an expert. When the clock is fully wound an internal mechanism will prevent you from winding any further. To wind the clock simply place the key, or crank, into the winding point and turn clockwise sixteen revolutions. Although British dial clocks are meant to be wound using a key, using a crank is much easier. To wind the clock use either a number 11 key or a number 10 crank. To be called a clock, a devise must both keep time and have either a strike or chime mechanism.īritish dial clocks typically have a fusee movement with one winding point, located in the center of the dial. Timepieces only keep time they don't chime on the hour or quarter hour. A clock with only one set of gears is correctly referred to as a timepiece. They typically have one set of gears with one winding point. WINDING AN ANTIQUE BRITISH DIAL CLOCKīritish dial clocks are time-only spring driven clocks. By winding every seven days you prevent the clock from stopping.

It's always a good idea to wind them every seven days. Additionally, most clocks are set to run for eight days, before having to be wound. Clocks with two and three gear sets will be able to chime on the hour and quarter hour respectively. The reason clocks have multiple gear sets is so a clock can chime on the hour and quarter hour while it keeps time.Īll clocks require at least one set of gears dedicated to keeping time. Please refer to the picture below showing a dial with three winding points. To determine how many winding points your clock has, look at the clock dial and count the holes where a key can be inserted. When there are three winding points, there will be three gear sets within the movement. When there is only one winding point, the movement will only have one set of gears. In general, the number of winding points correlates to the total number of gear sets.

#1950s swing clock mini grandfather how to#

This tutorial will explain how to wind the following clocks: Although there are many different kinds of clocks, they can be broken down into several different categories according to how they are wound.

Some clocks are wound using a key or crank, while others are wound by pulling on a chain. Most clocks will have one, two, or three winding points. This is because there are different types of clocks and some can have more than one winding point. Although the concept seems fairly simple, the actual winding of a clock can be quite confusing.